[Roadsters] Cast iron distributor mount

[Graeme]

Yes is has a bush at the base of the ditributor that fits down inside a
sleeve in the block.
One you remove the two retaining fasteners, one each side of the distributor
base, you can twist the dist. to break it free, then lift it to slide it
out..
If it has never been removed before, from your knowledge, it is probably
quite stuck in that sleeve.
Once it starts moving dose it with WD-40 and let it soak before trying
again.
It is only stiction keeping it in there. 

"How does one remove the cast iron distributor mount off the block?"

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.503 / Virus Database: 269.16.8/1153 - Release Date: 26/11/2007
9:08 PM