[Roadsters] wiper recomission suggestions
dave
daveandlindab at comcast.net
Thu Feb 14 20:39:38 MST 2008
I checked mine, they worked SLOWLY, so I didn't think about them again until
a downpour on the way out of The Glen. The started slow, and gradually got
better and better, but it was a bit stressful in a downpour hoping they
would keep working. I guess the old dried up grease finally melted and
started working. The amazing part is I was using a couple of tightly rolled
up blue paper shop towels as a top-to-windshield weatherstrip, never put the
new seal on after replacinf the top. It didn't leak a drop in a 4 hour
drive in heavy rain.
I agree with the suggestion to isolate the mechancal and electrical sections
and check them. I would guess one or both of the pivots are stuck.
Whatever solvents, peneetrating oil, explosives etc used to get them free, I
would make sure there is a way to get a good "sticky" lube in there after it
is all cleaned out so it stays lubed and won't wash or run out over time. I
would guess they were greased from the factory, so there is probably a brass
bushing in there..
Good luck
Dave
-
----- Original Message -----
From: "Fergus OFarrell" <fergus06 at socal.rr.com>
>
>
> Any suggestions as to where to start? ......
More information about the Datsun-roadsters
mailing list