[Roadsters] Vibration

[Mark]

  Yikes! I didn't know there were any markings!  While it is up on the 
stands, I will certainly look - mine still has the rubber boot over the 
shaft...is it under that?
Thanks!

On 9/1/2010 6:01 PM, Bill Cole wrote:
> Mark, Unless you can locate the splined yoke's alignment mark through 
> the shifter hole, I would remove the driveline and yoke and match up 
> the all "0" stamp marks that they have on them , they are not easy to 
> see but they are there. Your driveline could still be 180 degrees off 
> from where it originally was if you do not know where the "0" is 
> located on the splined yoke, hope this helps... Bill