[Roadsters] measuring a cam

[Tim]

OK, one more piece of info needed here....

This is supposed to be a reground cam so no "B" stamp.

thanks


On Wed, Dec 7, 2011 at 7:53 AM, Tim wrote:

> I guess I might need to be more clear...
>
> I want to determine if 2000 cam I have is actually the "B" grind I was 
> told it was when I bought the head. So I need to measure for lift and 
> duration (right?) to determine the grind of this cam.
>
> Thanks!
>
> On Wed, Dec 7, 2011 at 6:10 AM, Tim wrote:
>
>> Can someone please send me a picture, drawing, diagram, hyrogliphic, 
>> .jpg, .gif, bitmap, etc that clearly shows where I need to put the 
>> micrometer in order to get an accurate measure of a cam shaft?
>>
>> A shot of a cam with the micrometer actually in/on the two spots 
>> needed to be measured would be greatly appreciated.
>>
>> Thanks very much!!!
>>
>> Tim
>> ________________________________________