[Roadsters] Oil leak

[Dan Kroninger]

The rubber ring is on the old filter, and my car does not have a drain tube in
the filter housing.  It could be possible that the new one does not have a
rubber ring though, I'll check that.

Thanks,
Dan

> Subject: Re: [Roadsters] Oil leak
> To: d_kroninger at hotmail.com; datsun-roadsters-bounces at autox.team.net;
datsun-roadsters at autox.team.net
> From: cour.jpeg at gmail.com
> Date: Tue, 4 Oct 2011 20:27:55 +0000
>
> Sometimes the rubber ring from the old filter will stay stuck on the engine
mounting base. You may also have gone to a shorter oil filter and the
standpipe is keeping it from seating fully.
>
> Top of my head.
>
> Another ~ZoltVolt~ wireless picture msg
>
> -----Original Message-----
> From: Dan Kroninger <d_kroninger at hotmail.com>
> Sender: datsun-roadsters-bounces at autox.team.netDate: Tue, 4 Oct 2011
13:09:24
> To: Datsun Mailing List<datsun-roadsters at autox.team.net>
> Subject: [Roadsters] Oil leak
>
> Hey listers,
> I have an oil change question.
> Last sunday I changed the oil in my 1600.  Everything went fine, no
immediate
> leaks, crush washer installed and new filter added with the seal lightly
> lubricated with oil.  I topped the car up with fresh oil and then went
about
> my day.  Last night, I started the car to try to determine if I had fixed a
> coolant leak that I had.  Turns out the leak was not fixed, but that is a
> different story.  When I left for work this morning, I found a huge puddle
of
> Motor oil under the car.  More than a small leak, I am talking two or three
> quarts!  I looked under the car this afternoon and cannot determine if the
> leak came from the plug or the filter.  I cannot turn the filter any
tighter.
> It does not appear that the oil plug is leaking.  Here is the question, when
I
> put the copper crush washer on the plug, I put the smaller diameter against
> the plug head, and the larger diameter side against the pan.  A friend
> mentioned that he thinks it should be the other way, with the smaller
diameter
> side against the oil pan.  Does this matter?  Since mine was backward of
what
> he said, I took it off, drained and replaced the washer with the small side
> against the pan, but I am afraid to refill and run the car as I don't want
4
> more quarts on the floor.
> Would having this washer on backwards be enough to let the oil come out
when
> hot but not when cold?  Any other thoughts.  I had no major leaks before and
I
> used 20W 50 oil with the same filter as the one I just took off.  Any
thoughts
> would be greatly appreciated.
> I am off to spread the kitty litter.
> Thanks,Dan
> ________________________________________
>
> datsun-roadsters at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/courjpeg@gmail.com