[Roadsters] EI Dizzy install
Stan Chernoff
az589 at lafn.org
Sat Jul 14 17:46:55 MDT 2012
You can't depend on the timing being correct when you install the new
distributor. If you didn't receive the hold down plate with the
pointer it will need to be transferred. Since there are two
adjustments associated with the pointer hold down plate it is
necessary to set the timing. If the EI was set up correctly it
should not be necessary to reset the intermediate gear that runs on
the cam. The supplier should be able to guide you on the setup.
Stan
==========
At 10:15 AM 7/14/2012, Dan Kroninger wrote:
>All,
>
>I received my shinny new EI dizzy the other day and was thinking about putting
>it in today, but I am confused about one thing.
>
>In the manual and on 311s it seems that if I have a good running car, which I
>do, I should be able to mark all the current settings and rotor location, pull
>the old one out, drop in the new one, swap out coil, bypass resistor, install
>gapped plugs and wires, and go. Basically no trimming resets.
>
>Would that be correct? Will I have to reset timing and what not, or should I
>be able to swap and go? I just want to clarify this before taking it apart.
>Thanks all for your help
>
>Dan
>________________________________________
More information about the Datsun-roadsters
mailing list