[Fot] TR3 bore sizes?

[N197TR4 at cs.com]

I have been getting correspondence from Drayton Sleeves. They appear to be a 
very serious producer of sleeves, including custom sleeves.

Anyone have any experience with them?

Joe (A)


> Had an email comunication with Ken late last week to see if he had 92's and 
> his response was that he did not due to difficulties with machining, etc.
> 
> Bill Babcock <BillB at bnj.com> wrote:  Yup, Ken gillanders has nice flat top 
> wisecos and sleeves from LA Sleeve. I'm
> going to use the 92mm in my street TR3.
> 
> -----Original Message-----
> From: fot-bounces+billb=bnj.com at autox.team.net on behalf of Mark J. Bradakis
> Sent: Tue 8/28/2007 9:00 PM
> To: FOT at autox.team.net
> Subject: [Fot] TR3 bore sizes?
> 
> So this local club member brings in his TR6 for some work (stuck
> Grose Jet in rear carb) and we start talking about his TR3 project.
> 
> Can 89 mm piston sets be had that will make a reliable, streetable
> motor?
> 
> mjb.
> billb at bnj.com
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
> adcronin at ameritech.net
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
> 
> 
> 
> Planning & Development Services
> A. Daniel Cronin
> 248 761-2673
> _______________________________________________
> 

   </HTML>