[Fot] viton seals for TR6

[Don Elliott]

Jack - On my TR3A, I had to change the front seal and couldn't get a 
speedi-sleeve that would do the job.  So I spoke to a seal supplier and we 
found a new seal with a slightly smalled ID that was available and it was a 
very standard part.  Then I turned down and polished the OD of the shaft 
where it was worn with a groove and polished it to the correct diameter for 
the new seal.  It doesn't leak now and I didn't need to use a speedi-sleeve.

Don Elliott, Montreal


----- Original Message ----- 
From: "Jack W. Drews" <vinttr4 at geneseo.net>
To: <fot at autox.team.net>
Sent: Sunday, April 13, 2008 9:03 PM
Subject: [Fot] viton seals for TR6


>I need to replace the front diff seal and the front crank seal on my
> TR6. I replaced them both, along with Speedisleeves, not too long
> ago, but they are leaking too much to put up with.
>
>
> I'd like to be able to buy the seals prior to disassembling and
> measuring the iron pieces if someone has the specs.
>
> Thanks
>
> uncle jack
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> You are subscribed as 58tr3a at videotron.ca