[Fot] Flywheel Fasteners for Steel Flywheels

[Chuck Arnold]

I have eight extra of the Ford ones -- paid Summit about $8 each I think.
Will sell.

On Tue, Apr 22, 2008 at 7:28 AM, Tony Drews <tony at tonydrews.com> wrote:

> If 3/8 " -24 bolts (stock diameter): ARP p/n: 206-2802 (BMC A series
> is the intended application)
> If 7/16 " -20 bolts (I favor these): ARP p/n: 350-2802 (Ford 351
> Nascar V-8 is the intended application).  These use a 3/4" socket and
> are 12 point.
>
> No washers, red loctite, you have to grind a little off the end of
> the 7/16 bolts.
>
> - Tony
>
> At 08:44 AM 4/22/2008, N197TR4 at cs.com wrote:
> >FOT,
> >
> >The steel flywheels are arriving at their intended destinations and I
> have
> >been asked what I would recommend for fasteners.
> >
> >What doth the list sayeth?
> >
> >This is a worthy question.  I use a particular fastener (4) with Loctite
> and
> >no washers or locking tabs.
> >
> >It would be good to see a consensus on keeping this rotating mass in
> place. I
> >likely have no more than 125HP and seldom go beyond 6,000 RPM. Thus, the
> >answer maybe different for others.
> >
> >Joe A   </HTML>
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> You are subscribed as triosan at gmail.com
>



-- 
Chuck Arnold