[Fot] TR6 piece between radiator and motor

[Larry Young]

Joe,
How much camber adjustment have you gotten with this setup?  If I'm 
looking at this right, for each degree camber change you'd have to move 
the top of the tower in by (pi/180)*(length of tower).  I haven't 
measured the length from crossbar to the bottom of the tower, but let's 
say it's 10 inches.  That works out to 0.17 inch for one degree of 
camber change.  That seems doable, but to go from stock camber of -2 
degree to +2 degree would require about 0.7 inches.  This is for each 
side, so the cross piece would have to be shortened by 1.4 inches.  This 
seems like a long way to bend those towers.
Larry Young
> It can be adjusted (RH/LH Threads) to change camber.
> Kas liked it...(he took the tubes and sectioned them to induce more camber)
> Uncle Jack likes it.