[Fot] TR4 rear main seal

[WEmery7451 at aol.com]

In a message dated 11/12/08 9:24:16 PM Pacific Standard Time,
tony at tonydrews.com writes:

<< I know that Jack has done this in the past, but don't know the   details on 
the flywheel that was installed.  He also has replaced the   rear seal this way
, but I have no idea how he pulled that off.   >>
The shop manual shows a special tool that pulls the rear main straight down.
I made one of these with only a fire ax, drill press, and buzz box.  Cut a
strip of metal from some plate (or use bar stock).  Drill two holes in the ends
and weld nuts over the holes on one side.  Two bolts thread into the nuts.
Drill two smaller holes between the nuts so that the bar stock could be bolted
to the main cap.  Tighten the bolts threaded into the nuts, and the cap can be
easily pulled down and out.

Yes, many times I had plenty of Permatex slopped in my face and hair while
pounding in felt underneath the car while lying on my back.
**************
Get the
Moviefone Toolbar. Showtimes, theaters, movie news &
more!(http://pr.atwola.com/promoclk/100000075x1212774565x1200812037/aol?redir=h
ttp://toolbar.aol.com/mo
viefone/download.html?ncid=emlcntusdown00000001)