[Fot] Ignitionl issues now source of Crane Ignition anyone have a source?

[n197tr4 at cs.com]

I am looking for a CRANE breakerless ignition for my AMBRO.

Thanks!? Joe A


-----Original Message-----
From: Greg & Alison Blake <ablake2 at austin.rr.com>
To: 'Joe Boruch' <jaboruch at netzero.net>
Cc: fot at autox.team.net
Sent: Wed, 8 Apr 2009 10:33 pm
Subject: Re: [Fot] Ignitionl issues



I am running an alternator and have not had a problem with the cut-off,
it kills the engine every time.  I will go ahead and switch the coil
through a separate ignition switch just to be safe.  Some have mentioned
that the coil needs to be fed with a wire that has a resistor in it.
Any idea on what that should be?  Currently, I am running full 12v from
the battery.  Also, should that resistor be bypassed when the starter is
engaged?
 
I have checked voltage to the timing light, 12v.  The wires are a 8mm
silicon jacket, low resistance wire.  They were purchased at Autozone as
a kit that had to be trimmed to fit and then assembled.
 
Thanks,
 
Greg
 
-----Original Message-----

________________________________________________________________________
Email message sent from CompuServe - visit us today at http://www.cs.com