[Fot] Harmonic Dampener Question

Robert Lang lang at isis.mit.edu
Thu Apr 16 08:40:22 MDT 2009


Hi,

Update on the crank thing... I measured the crank to the best of my 
ability (I have to admit that it takes me a while to recall how to read 
micrometers properly... well that and the fact that I have a lot of 
trouble seeing the gradations on the micrometers, but I digress) and the 
crank is round (to within .0005) and it also true to within the capability 
of my dial indicator. I did discover that the crank end-float is slightly 
out of spec, but it's a TR6 - I think that's a given (and I have a box of 
thrust washers to play with.

What I wound up doing was installing the Goodparts ATI superdamper. When 
the parts arrived, I sat reading the directions and then went around the 
shop and garage picking up this and that (like a brake hone) in case I 
needed to "help" the fitment... the thing literally bolted on. The part on 
the crank is nice and tight, but almost no effort was needed to draw it in 
place. This was a very pleasant installation... highly recommended.

So now I move on to the next "issue". I'm installing a head that is 3.290" 
think. Yes, that is not a misprint. I cc'd the head and the combustion 
chambers are 36cc's pretty much what I was looking for 11.9xx:1 +/-

But the head is so freakin' "thin" that the studs are interfering with the 
rocker pedestals. UGH.

So here's the next question: could someone please provide me with the 
dimensions of the ARP head studs for TR6 / GT6? Especially, the difference 
in the length of the ARP studs to the stock pieces. I'm trying to 
determine if I should bite the bullet and install a set of those or if I 
should just shim the pedestals to get another .020" or clearance (I'm 99% 
sure that's all I need.

Of course I already installed the head gasket and torqued the head, so 
toss in a new head gasket (I presume) for good measure. Unless someone can 
convince me otherwise.

Regards,
rml
---------------------------------------------------------------------------
Bob Lang              NER/SCCA                 |  This space for rent
Solo Chair 2008       TR6 40 F Prepared        |  Triumph!
Voice:781-438-2568    FAX: 617-258-9535        |  Cell: 339-927-4489
---------------------------------------------------------------------------



More information about the Fot mailing list