[Fot] Harmonic Dampener Question... now studs
Robert Lang
lang at isis.mit.edu
Thu Apr 16 10:54:57 MDT 2009
Hi,
Thanks for the advice.
The pushrods should be all set, they are .120 shorter than stock. The
former head was about .025 thicker - not a huge change.
I'm 100% certain that the studs were bottomed in the holes less about 1/4
turn and the nuts are not bottoming on the unthreaded portion of the
studs. I did check that.
I'm a tad leery about trimming the existing studs, but I only gotta take
off maybe one complete thread. I've done that plenty of times with
trailing arm studs.
Thanks again...
Regards,
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
More information about the Fot
mailing list