[Fot] (no subject)

Rob 19to1tr6 at comcast.net
Thu Feb 11 17:12:22 MST 2010


I have had some bad results with uneven brake bias.At one time I had just 
the proportioning valve going the the rear brakes after the rears were up 
graded to discs on my Tr 6
  The trouble was I could never take enough  psi off the rear and that was 
not good The tilton system is not to costly and considering  the infinite 
adjustment from the cockpit. I would not want to be stuck with a shim 
adjustment.
  Now I can set them up as I like and don't have to settle for "there all 
most what I want"    good luck with your decision.     rob    ps If you go 
with the tilton set up and need the sizes  on the masters etc I will be 
happy to look them over and pass on the data I have 2 or 3 new masters that 
I could not use either to small or large  can't remember
----- Original Message ----- 
From: "Bill Bartlett" <BillBartlett at wingnutracing.com>
To: <fot at autox.team.net>
Sent: Wednesday, February 10, 2010 9:58 PM
Subject: [Fot] (no subject)


> Hi Gents,
> I am curious on  the difference between brake "Biasing" and brake
> "proportioning"?
> Given that one has a set up with twin masters, one each  for the front and
> rear brake systems, is it better to use a bias adjustment cable from  the
> cockpit to adjust the amount of force given to the front and rear brakes, 
> or
> should one use a proportioning adjustment valve. The bias bar appears to 
> work
> by adjusting the amount of force the pedal excerpts on the two masters, 
> where
> the proportioning reduces the amount of hydraulic force excerpted thru the
> rear brake line to the slaves.
> What is the deal? Does the Biasing do the heavy lifting and the 
> proportioning
> the micro adjustment? I suppose one needs to start with the right master 
> bores
> to start with eh?
> My car has a bias bar but it is only adjustable by inserting different 
> length
> bushings between the clevis and the spherical bearing at the top of the 
> peddle
> assembly. I am debating whether to upgrade to the Tilton adjustable pedal 
> set,
> put a proportioning valve in or just leave it alone and have different 
> bushing
> sets for say wet and dry?
> Thoughts?
> And thank you for your time
> Bill
> PS; this is for a GT6
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.96
>
> You are subscribed as 19to1tr6 at comcast.net
>
> http://www.fot-racing.com
>
>
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> Brought to you by Team.Net consulting - Unix software specialist.



More information about the Fot mailing list