[Fot] TR4 diff disassembly

[Dennis DeLap]

I like using a case spreader.  You can make one easily with two pieces of angle iron and some threaded rod.

-----Original Message-----
From: "Scott Janzen" <Janzen at REcatalyst.com>
Sent: ‎9/‎26/‎2013 9:12 PM
To: "'Friends of Triumph' Triumph" <fot at autox.team.net>
Subject: [Fot] TR4 diff disassembly

So, i am pulling apart the rear axle to send it to Southwick for conversion.  I'm working without a shop manual - and want to pull the differential out of the housing.  I've removed the bearing caps.  Do I need Churchill Spreader xyz, and is there a good/cheap substitute?  It does not want to pop out with the persuasion of a pry bar.


BTW, there's a Detroit locker . . . any special instructions?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20130926/67b92773/attachment-0001.htm>