[Fot] TR4 diff disassembly

[Todd Redmond]

The rope trick works

Tie a rope to the carrier and hang the entire axle from a vise.  Use a soft faced hammer and hit the the housing on both sides of the carrier. The housing will drop to the floor.   Note:  don't hang it too high off the ground!!  

Todd

Sent from my iPad

On Sep 26, 2013, at 10:12 PM, Scott Janzen <Janzen at REcatalyst.com> wrote:

> So, i am pulling apart the rear axle to send it to Southwick for conversion.  I'm working without a shop manual - and want to pull the differential out of the housing.  I've removed the bearing caps.  Do I need Churchill Spreader xyz, and is there a good/cheap substitute?  It does not want to pop out with the persuasion of a pry bar.
> 
> BTW, there's a Detroit locker . . . any special instructions?
> _______________________________________________
> fot at autox.team.net
> 
> http://www.fot-racing.com
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/alfetta95@optonline.net
> 
>