[Fot] A-Type O/D Testing

[Tim Murphy]

I was able to test my A-type connected to the transmission with a 1/2 inch
drill chucked on the nose of the transmission input shaft.  I got 340 PSI at
about 2500 RPM drill speed and the transmission in 4th gear.  I have a
Milwaukee 2-speed 1/2 inch drill.  So I'd guess 400 RPM is not enough.

Tim 

-----Original Message-----
From: Fot [mailto:fot-bounces at autox.team.net] On Behalf Of Glenn Franco
Sent: Sunday, June 22, 2014 5:07 PM
To: Friends of triumph; 6pack at autox.team.net
Subject: Re: [Fot] A-Type O/D Testing

Let me try this again since the site has been down.

On 6/19/2014 5:02 PM, Glenn Franco wrote:
> Group
> I'm trying to bench test an A type that I overhauled this past winter 
> from a box of parts.
> I also have an A type that I took out of a 71 TR6 that I would like to 
> test before using them in any cars.
>
> 1st dumb question
> What do you think the minimum input shaft speed needs to be to allow 
> the O/D to engage.
>
> I fabricated an adapter from a clutch hub and various pieces of steel 
> on a lathe to drive the trans from the input shaft.
>
> I'm spinning the adapter with a large 1/2 inch drill but the max drill 
> speed is only a little over 500 RPM which is probably not enough.
>
> I get oil flow up the operating valve when the plug is removed but no 
> engagement. This is the result of spinning both transmissions.
>
> Any suggestions/more RPM's
> Thanks Glenn
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/timmurph@fastbytes.com


[demime found a multipart/alternative section which it tried
to parse but could not find any section which it could render. Please send plain text.]