[Fot] TR4 lower wishbone bushings

[Dave]

Hi Bob,
I had a machine shop hone them after I installed the bushings.  Low cost and done correctly.  

Dave H.

Sent from my iPad

> On Nov 7, 2016, at 6:02 PM, Bill <ponobill at gmail.com> wrote:
> 
> You shouldn’t need to ream them, the bushings I have always used fit as is. 
> 
> 
>> On Nov 7, 2016, at 1:21 PM, Robert Blake <rblake36 at yahoo.com> wrote:
>> 
>> I am installing new bushings on the lower wishbones of my TR4 and my challenge is now to hone them to the right ID to fit properly on the trunnion.  I have not been able to find a hone small enough to fit the bushings.  Any suggestions would be welcome. 
>> 
>> Cheers,  Bob Blake
>> _______________________________________________
>> fot at autox.team.net
>> 
>> http://www.fot-racing.com
>> 
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/bill@ponostyle.com
> 
> _______________________________________________
> fot at autox.team.net
> 
> http://www.fot-racing.com
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/dlhogye@comcast.net
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20161108/ee7b6453/attachment-0001.htm>