[Fot] Excess GT6 stuff for the taking

Scott Janzen sjanzen at me.com
Sun Sep 9 18:48:01 MDT 2018


oops, here’s the list.
 

1.            fuel pump

2.            lucas license plate glass lens

3.            6 clutch pressure plates

4.            5 bell housings

5.            4-5 intake manifolds

6.            2 pair Stromberg carbs

7.            3 rocker arm assy, 1 clean, 1 incomplete

8.            6 stock con rods, surface rust, with wrist pins

9.            12 timing chain covers, good, bad and ugly

10.         misc window cranks ,door latches, solenoid, lug wrench, window track

11.         2 alternators

12.         3 windshield wiper motors, 2 different styles

13.         5 crankshaft pulleys

14.         used timing gears and chains – lots

15.         2 crank pulleys, one rear upright, water pump assy, several sets head studs, alternator bracket, late model gas pedal

16.         anti-roll bar

17.         50 main bearing caps, 19 rear main seal housings, 14 front sealing blocks

18.         2 heater coils with fans, one cooling fan blade- 8, 2 diff access plates

19.         8 valve covers, varying condition, mostly fair, nothing remotely show worthy

20.         2 speed wiper washer switch, new in box

21.         aftermarket air filter

22.         lucas distributor and base – 416978 45DE4, shiny/clean but used, 2 more manifolds, clutch release fork, etc

23.         4 horns, e. brake lever, 2 yellow 8 blade fans, 1 blue 13 blade, h2o pipes, Muncie shift boot and chrome, 2 front discs, hubs

24.         small cardboard box of misc seals, cam locators, oil slingers, valve retainers, etc

25.         VTR exc cond 40-58, Triumph parts catalogue “Graphic” GT6 Mk3 – Miller box

26.         SW Mech tach, Sun Supertach, Piston rings (hastings, Deves, look usable),

27.         1 set new TR6 pistons 0.020 over, 1 set used

28.         minilite lug nuts, set, starter shims, new carb gaskets (box full), heater vents, hoses, eyeball vents, all fittings (good cond), misc suspension bushings – no photos

29.         5 front engine plates

30.         right rear bumper, crazed chrome, slightly bent

31.         2 tr7 elec rad fans

32.         six alternator mounting brackets

33.         one idler pulley

34.         rocker arm parts and pedestals

35.         1 brake backing plate

36.         1” alum wheel spacers (2)

37.         4 headlight buckets and retaining trim

38.         several round chrome marker light housings

39.         11 oil filter housings

40.         3 late model master cylinders

41.         1 early master

42.         3 clutch slave

43.         2 clutch master, one angled, one upright

44.         2c cast brake line manifolds

45.         4 clutch forks

46.         several wheel cylinders

47.         5 sealed beam headlights - Westinghouse

48.         10 oil pumps, mostly rectangular pickup, one basket; several bypass plungers and springs

49.         engine mounts (lots), heater valves

50.         Stromberg carbs (8), some linkage, 4 tee fuel lines (aluminum?)

51.         5 rear half shafts, misc u joints

52.         2 drivers side vent windows and frames, 5 rear quarter windows

53.         ATL fuel cell box, plate and cap, 12 x 20 x 8.25, not rusted

54.         9 con rods with pistons

55.         (1) 10 spline raybestos clutch disc, new

56.         filter housing, mecca, cast aluminum, large

57.         ‘70 charcoal canister

58.         5 dist gears, 3 steel distributors, bunch of pedestals

59.         lots of cams, provenance unknown

60.         2 rear deck lids with glass, one with defrost

61.         2 driveshafts

62.         1 door glass

63.         1 sleeved block

64.         3 engine backplates

65.         Drive Shaft

66.         Box of oil pans

67.         Box water pumps and pulleys

68.         3 radiators

69.         4 flywheels

70.         Box of interior parts



On Sep 9, 2018, at 10:56 AM, Scott Janzen via Fot <fot at autox.team.net> wrote:

I’ve attached a list of what’s left of a massive GT6 parts stash I picked up a few years ago.  Most of this stuff is going to the scrap heap unless some of you want it, as it is taking up too much space in the basement and I have no future need for it.  Let me know what you want and i will ship it to you at your shipping cost, but the parts are free.  Hate to scrap the pile but I really don’t want to be in the fleabay parts business.  I think this list is still accurate as I’ve edited it down for stuff I know is gone.  Let me know if any interest and I’ll look for it.  I’d love to give the ENTIRE STASH to someone who wants it all.  Note - all of these are used parts - nothing new.

I also have the following, new parts, which I don’t have a use for.  These I’d like to sell - about 50% of retail price, whatever that is.  Make me an offer.
GT6 clutch pressure plate, NOS, Laycock and Sheffield
GT6 tach cable, new
GT6 solid center racing clutch disc, new, TS Imported
Scott Janzen
Wyndmoor, PA (just north of Philadelphia, near the PA turnpike if you want a lot of stuff and want to pick it up)



_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/sjanzen@me.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20180909/30c9f087/attachment-0001.htm>


More information about the Fot mailing list