[Fot] Valve overlap and compression test

[van.mulders.marcel at telenet.be]

A leaking test on my TR6 engine is showing a leaking exhaust valve on cyl no 1 (48% on the gauge of the device) and a leaking inlet valve on cyl no 2 (75%). Compression on cyl no1 is 9.5 bar and on cyl 2 it is 8 bar. The compression on the other cylinders is between 12 and 13.5 bar. This is with a race cam with a valve overlap of 110° (320-F grind). Because of the high overlap, the piston has risen a lot before the inlet valve is closed, so I did the compression test again, but with a valve lash of 2.5mm/0.1" : compression went from 9.5 bar to 14.5 on cyl no 1 and from 8 bar to 15 on cyl no 2. With this valve lash, the compression on the other cylinders went up to 16 - 18.5 bar. Of course, when the engine is running at high rpm, a lot of valve overlap is necessary for best cylinder filling, but I wonder if 110° isn't too much?? The recommended valve lash is 0.40mm/0.016" when the rocker ratio is 1.45(0.43mm/ with my 1.55 roller rockers). Would it be risky to set the valve lash at some 0.05mm/0.002" higher? 
PS : is it common practice to set the valve lash at a couple of mm to perform a compression test, because it seems that the valve lash has a lot of influence on the result when testing a race camshaft? 
Marcel 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20200502/2be00348/attachment-0002.htm>