[Fot] Southwick Conversion axle float

[Henry A. Morrison]

Great, another project!  Thanks for the info.............

Henry Morrison
________________________________
From: Fot <fot-bounces at autox.team.net> on behalf of Philip Gott via Fot <fot at autox.team.net>
Sent: Friday, February 17, 2023 2:27 PM
To: Philip Gott via Fot <fot at autox.team.net>
Subject: Re: [Fot] Southwick Conversion axle float

Thank you for the advice.
I made a shim out of a bronze thrust washer purchased from McMaster Car (part number 5906K528). It fits over the 2” OD  bearing retainer shrunk on the shaft, although i opened it up about .040 to give some clearance. The OD of the thrust washer needs to be turned down a bit to fit inside the axle housing. It is just about the same thickness or .002” thicker than the backing plate, so the bearing will be captive and have no end play.  As some of you advised, this will go inside the bearing housing rather than inside the backing plate.
See you at Road America!!!
Phil
[cid:b5ec3388-920e-4d28-a8f3-e5e48b0ca502 at NAMP223.PROD.OUTLOOK.COM]


from my iPhone

> On Feb 12, 2023, at 8:01 PM, Philip Gott via Fot <fot at autox.team.net> wrote:
>
> Starting to reassemble my rear axle after a successful install of a new ring and pinion (thanks the help and advice on that one, FOT). When putting in the axle shafts I noticed an indentation on the axle bearing retainer from the bearing slamming sideways into it. Southwick machined the bearing housing ends the full width of the bearing. Because the backing plate fits over the bearing, there is nothing to keep the bearing all the way in the bearing housing, and it shifts side to side in the void left between the retainer and the backing plate.
> One solution would be to find some steel wire the same thickness as the backing plate and form it into ring inside the hole in the backing plate.
> Does anyone have any other solutions or recommendations?
> Phil Gott
>
> Sent from my iPhone
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/dos_gusanos@msn.com


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20230218/0a90f168/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image0.jpeg
Type: image/jpeg
Size: 746477 bytes
Desc: image0.jpeg
URL: <http://autox.team.net/pipermail/fot/attachments/20230218/0a90f168/attachment.jpeg>