[Fot] Rear Main Cap

[ralph hansen]

 main caps are machined as a set to the block itself - if you need to replace a cap, good luck finding a cap with the grooves lining up / if you do get lucky you'll need to get the block and caps line bored to make it all work properly

    On Saturday, March 18, 2023 at 08:26:23 AM CDT, Rod Pierce via Fot <fot at autox.team.net> wrote:  
 
 The image shows the rear main cap and bearing on a small journal 1300.
As you can see, there is an offset between the two bearing halves. 
I was attempting to mix and match parts from my parts bin.
I'm curious about the source of the offset.  Is there a difference in end caps from year to year on the 1300 or is there a difference from engine to engine when they were manufactured?_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/quikrx@yahoo.com


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20230318/528c728f/attachment.htm>