[Fot] How many times can you line bore a block?

[Philip Gott]

Lunker ;
I did not….
Regards,
Phil

Sent from my iPhone

> On Aug 3, 2026, at 5:16 PM, Lunker Hilyer <lunkercars at icloud.com> wrote:
> 
> Did any of you receive my oversimplified approach to repair of this not uncommon issue?
> Lunker
> 
>> On Jul 28, 2026, at 8:25 AM, Chuck Gee <chasgee22 at gmail.com> wrote:
>> 
>> I could be wrong, but I don’t think line boring affects that dimension.  I understand it to be making the caps a little shorter then reboring to match the upper diameter in the block.  
>> 
>> Otherwise, a bunch of other dimensions would be goofed up too.
>> 
>> Chuck Gee
>> 
>>>> On Jul 27, 2026, at 4:56 PM, Philip Gott <vfracing at aol.com> wrote:
>>> 
>>> Or another way to ask the question is “how much misalignment between the crankshaft and transmission input shaft can be tolerated?”
>>> I had a block completely gone through, including line boring and it ran very well until number one cylinder liner suddenly split. The engine hydro locked and broke the crank and front main bearing cap. I have a new cap; to use it requires the block be line bored again. I’m wondering if anyone else has a similar experience and can tell me either that it worked out well, or that I should throw the block away.
>>> Thanks as always!
>>> Phi
>>> 
>>> 
>>> 
>>> Sent from my iPhone
>>> _______________________________________________
>>> fot at autox.team.net
>>> 
>>> http://www.fot-racing.com
>>> 
>>> Donate: http://www.team.net/donate.html
>>> Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
>>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/chasgee22@gmail.com
>>> 
>>> 
>> _______________________________________________
>> fot at autox.team.net
>> 
>> http://www.fot-racing.com
>> 
>> Donate: http://www.team.net/donate.html
>> Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/lunkercars@yahoo.com
>> 
>>