[Healeys] Dipper switch wiring harness routing BJ8 RHD

[Rich C]

Wes,

Wrong guess. The 3 wires for the dip switch emerge from the main bulkhead 
harness almost in the middle of the bulkhead, engine side. The dip switch 
harness plugs in to the main harness and then proceeds along to the left 
side of the car (RHD car) running parallel to the main harnness and sharing 
the big double sized harness clip right beneath the fuse block. When it 
reaches the scuttle support member on top of the driver's foot box it goes 
down over the outboard edge of the structure and in through the grommet 
located in the inner corner just beneath the fresh air duct ring and 
vertically down to the dip switch.

see pictures att'd.

Rich Chrysler

----- Original Message ----- 
From: "Weston Keyes" <westonkeyes at hotmail.com>
To: "Ahealey Ahealey" <healeys at autox.team.net>
Sent: Wednesday, March 04, 2009 1:17 PM
Subject: [Healeys] Dipper switch wiring harness routing BJ8 RHD


> Hello Folks,
>
>     I have a right hand drive BJ8. I am guessing the 3 wire harness from 
> the
> dipper switch on the floor stays inside the car until it emerges through a
> grommet just under the bracket for the choke cables. Can anyone confirm 
> that?
>
> Thanks
>
> Wes Keyes
> York, Maine
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler at quickclic.net
>
> http://www.team.net/archive

[demime 1.01d removed an attachment of type image/jpeg which had a name of dec07 034.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Oct08 029.jpg]