[Healeys] BJ8 Interior

[Mark Schneider]

The threaded studs for the shoulder harness straps do extend through  
the quarter panels and.  If you do not have a 3-point seat/shoulder in  
your car the threads can be protested and look a little improved with  
a couple of chrome  finishing nuts on top of them.  If the studs and  
other anchoring components were installed at the factory there should  
be two studs to each side of the cockpit,  I am not sure if I  
understand the other part of your question, ie, installing the rear  
seat squab and some interference with the quarter panels.  When I did  
my carpet job I had all of the interior out of the car.  The rear seat  
back is held in place by five bolts.  Three extend through wood frame  
at the bottom and through the body metal into the space above the rear  
axle.  Two more boltx, one in each of the rear wheel wells extend  
through the metal and into the side frame of the back.  I hope this  
helps.

Marks 3
1966 BJ8