[Healeys] 100-M SU carbs

[Bob Spidell]

I give up.  What's a 'bitza?'


bs


Ray Juncal wrote:
>     I have been following the thread on 100-M carbs.  I happen to be in the
> process of rebuilding two pairs of H-6s on 100-M manifolds.  I have had both
> sets since the early seventies  I don't think anyone was reproducing "M"
> manifolds at that time so I think they are legit.  The carbs came with the
> manifolds so the chances are good they may be correct also.  The carbs have
> the "AUC 6040 X" number but I cant see any other hand etched numbers.  On my
> H-4s there is a small plinth with hand etched "6000"numbers but the H-6s have
> no such dedicated number location.  Exactly where should I look for the hand
> etched numbers?    The bodies of the carbs I have only have one of the
> mounting bosses machined off.  All four bodies have three bosses.  According
> to previous posts, three bosses should have been removed leaving only one. Is
> that correct. If these carbs are not 100-Ms what could they be?  maybe from a
> 100-6 or 3000?  I have tried to find
>  photos of a 100-M engine showing the carbs in the books I have without much
> luck.  Not enough detail.    My cars are kind of bitzas so the info is more
> interest than necessity.  Anyone have anything to add?Ray Juncal
>   
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************