[Healeys] Fwd: HD8 adjustment

[Bob Haskell]

Geary,

The screws have a slot on the threaded end.  The two 'ears' are spread a 
bit to lock the screw in place.  You should be able to bring the ears 
back together and loosen the screws to adjust the throttle plate.  If 
you've got a couple of weeks, you might order some extra screws in case 
one of the ears starts to break off.

Cheers,

Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php

On 04/08/2012 09:28 AM, warthodson at aol.com wrote:
>   Alan,
> Thanks for the very good analysis of the problem. I agree the #1 is the most
> likely suspect. Next time I am involved in a fresh BJ8 startup I will try to
> inspect the throttle plate alignment. That should be in about two weeks. As I
> recall, aren't the two screws that hold the throttle plate on the shaft
> usually deformed (I think the term is "staked") to keep the screws from coming
> loose? That would make adjusting the throttle plates very difficult. I guess
> the solution is to inspect the carbs when they come back from the rebuilder,
> not after they are installed.
> Gary Hodson