[Healeys] Now that the Tranny is out -- Part 2

[Bob Spidell]

The 'cut' can be made quite satisfactorily with a cylindrical carbide bit in a die grinder (but heed John's advice). 

Bob 


-------------------------------- 
Bob Spidell - San Jose, CA 

----- Original Message -----


I had a shop cut my plate several years ago and they over-cut it on 
the bottom. I did not notice it at the time but the plate did not 
press against the small square cork gasket that sits in the rear main 
bearing recess. I don't know if it would have caused a problem 
because the car was not driven very much. I had it fixed by welding a 
small bit of steel flat stock. Be sure to check the cut carefully.