[Healeys] Hub bearing race install question

[linwoodrose at mac.com]

Hi Steve,
I did not heat the hubs, but I did put the races in the freezer. This worked well. Just be sure to drive in square and all should be fine.
Lin Rose

Sent from my iPad

On Nov 15, 2012, at 2:17 PM, "Steve B. Gerow" <steveg at abrazosdata.com> wrote:

> To install the front hub bearing races, I was going to heat the hubs in boiling water and freeze the races in my freezer.
> 
> Is this the correct procedure - or am I risking breaking the races by freezing them in combo with boiling the hubs?
> 
> Experience-based advice appreciated.
> 
> 
> -- 
> Steve Gerow
> Altadena, CA
> BN6
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/linwoodrose@mac.com