[Healeys] Rear Axle Hub Removal
Per Schoerner
per at schoerner.se
Wed Sep 6 00:52:10 MDT 2017
Mike
Note that the nut is an octagon, would fit better on an MG. And one of them is threaded the other way around. I made my own socket from a very big hexagon socket (46mm IIRC) that I grinded to an octagon.
Per
Skickat från min iPhone
> 6 sep. 2017 kl. 00:01 skrev Michael MacLean <rrengineer.mike at att.net>:
>
> OK, figured out how to get bearing hub off rear axle with a bearing flange and slide hammer. Is the hub nut 2 3/16ths? Is there a socket available without the chamfer around the mouth of the socket so I can get it on that thin nut? Do you guys just buy a 2 3/16ths socket and grind the mouth flat? The nuts on my axle are all buggered up from someone in the past using a chisel to get them off and put them back on.
> Mike MacLean
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20170906/feab8603/attachment.html>
More information about the Healeys
mailing list