[Healeys] Carburetor Heat Shield BT7 Mk1

[Michael Salter]

I believe that I still have several that were water jet cut using originals
as patterns.

M

On Mon, Nov 11, 2019, 4:16 PM Harold Manifold, <manifold at telus.net> wrote:

> I looked at the Moss kit but it isn't available anymore. Was the Moss heat
> shield made from Hardi Board?
>
> Harold
>
> ------------------------------
> *From:* Bruce Steele [mailto:healeybruce at roadrunner.com]
> *Sent:* Monday, November 11, 2019 12:59 PM
> *To:* 'Harold Manifold'; 'Ahealey help'
> *Subject:* RE: [Healeys] Carburetor Heat Shield BT7 Mk1
>
> Eric Grunden of Absolutely British worked with Moss to design their heat
> shield replacement kit, which uses cement board.  I used their kit when I
> last had my engine out a couple of years ago and found it to be a good
> quality reproduction that fit well.
>
>
>
> Bruce Steele
>
> Brea, CA
>
> 1960 BN7
>
>
>
> *From:* Healeys [mailto:healeys-bounces at autox.team.net] *On Behalf Of *Harold
> Manifold
> *Sent:* Monday, November 11, 2019 11:48 AM
> *To:* 'Ahealey help' <healeys at autox.team.net>
> *Subject:* [Healeys] Carburetor Heat Shield BT7 Mk1
>
>
>
> Help,
>
>
>
> Any suggestions on the best material to make a carburetor heat shield. I
> won't re-use the original asbestos part for obvious reasons. The metal part
> is fine and I just need the insulation material.
>
>
>
> Thanks.... Harold
>
> 1960 BT7
>
>
>
>
>
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20191112/4e73220e/attachment.htm>