[Healeys] Advice and guidance needed for OD reinstallation

[Bob Spidell]

Oops ... sent the wrong link (I need a proofreader).


On 8/27/2025 1:30 PM, Michael Salter wrote:
> Those "rings" are the Bellville washer and shim that go into the 
> adaptor plate to eliminate end float of the mainshaft bearing.
>
>
>
>
> ------------------------------------------------------------------------
> *From:* Healeys <healeys-bounces at autox.team.net> on behalf of Leonard 
> Berkowitz via Healeys <healeys at autox.team.net>
> *Sent:* Wednesday, August 27, 2025 3:50:01 PM
> *To:* healeys at autox.team.net <healeys at autox.team.net>
> *Subject:* [Healeys] Advice and guidance needed for OD reinstallation
> Hi. All
> I finally figured out how to get the OD out of my BJ7. Now for getting 
> the new one installed. I found two rings sitting on the output shaft 
> which I believe are fitted to the adapter plate. (See pics attached). 
> The problem is going to be how to keep them in place while maneuvering 
> the new OD into place. I was thinking of using either white lithium 
> grease or wheel bearing grease.
> Any suggestions?
> Thank you in advance for any help you can offer.
>
> Len Berkowitz
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20250828/50a09a28/attachment.htm>