[Healeys] The Story of Positive Earth (and Electrics 101)

Bob Spidell bspidell at comcast.net
Sun Nov 15 09:58:03 MST 2026


Jibes with my experience.

On 11/15/2026 7:00 AM, Michael Salter wrote:
> As an interesting note on this subject in one on their training 
> manuals Lucas indicates that their studies found that a 4 cylinder 
> engine took noticeably more starter pwer to crank than a 6 or 8 .
> My guess is that the pressure in any cylinder was completely 
> dissipated before a compression stroke started.
> Well I found interesting 🤣🤣🤣
>
>
> ------------------------------------------------------------------------
> *From:* Healeys <healeys-bounces at autox.team.net> on behalf of Bob 
> Spidell via Healeys <healeys at autox.team.net>
> *Sent:* Sunday, 15 November 2026 09:22:12
> *To:* josef-eckert at t-online.de <josef-eckert at t-online.de>; Healey, 
> Forum <healeys at autox.team.net>
> *Subject:* Re: [Healeys] The Story of Positive Earth (and Electrics 101)
> Nope.
>
> On 11/14/2026 11:18 PM, josef-eckert at t-online.de 
> <mailto:josef-eckert at t-online.de> wrote:
>>
>> I think that´s far over the top what you do. Have you ever tried just 
>> one of the two batteries?
>>
>> I use just one Harley Davidson motorcycle 12Volt, 35 Ah, battery 
>> which is covered by the original battery body top, left and right 
>> side. Only front and rear of the battery are not covered, which can´t 
>> be seen. The second is just a dummi. That works fine for me and it 
>> always gets the engine cranked in full speed to start it.
>>
>> Josef Eckert
>>
>> Konigswinter. Germany
>>
>> -----Original-Nachricht-----
>>
>> Betreff: Re: [Healeys] The Story of Positive Earth (and Electrics 101)
>>
>> Datum: 2026-11-15T04:24:13+0100
>>
>> Von: "Bob Spidell via Healeys" <healeys at autox.team.net> 
>> <mailto:healeys at autox.team.net>
>>
>> An: "healeys at autox.team.net" <mailto:healeys at autox.team.net> 
>> <healeys at autox.team.net> <mailto:healeys at autox.team.net>
>>
>> I got fed up with the 17H 6Vs I'd used for years; they were hard to 
>> find, would barely crank my BN2's (170+psi on all 4) rebuilt starter 
>> and came close to contacting the lid. So, I threw in the towel on 
>> original. IIRC, these are over 450CCA so two in parallel give close 
>> to 900A, with 00 cables linking them in parallel. The starter sounds 
>> stronger than my BJ8's with a 500CCA AGM.
>>
>> https://4xspower.com/collections/d-series-batteries 
>> <https://4xspower.com/collections/d-series-batteries>     (NFI).
>>
>>
>> If my (rudimentary) knowledge is correct, inductive loads like 
>> starters are almost dead shorts for a few milliseconds, until 
>> impedance builds as the motor starts to rotate (hence 450 amps). 
>> Besides the current draw, there will be a voltage drop, which reduces 
>> cranking power. I'd be interested in a voltage reading during 
>> cranking; old school load testers--the kind with carbon pile 
>> resistance--use the voltage drop to determine if a battery is good 
>> (and they usually test for 30 seconds or more). Of course, cold 
>> 20W/50 oil doesn't facilitate easy starting.
>>
>> One of my tractors--an early Ford--had a single 6V battery and pos. 
>> gnd. and starting it was a coin toss. It would only crank, very 
>> slowly, for about 20 seconds before giving up the ghost. I recently 
>> converted it to 12V neg. gnd. and it snaps to life on the first or 
>> second crank.
>>
>> Bob
>>
>>
>> On 11/14/2026 10:52 AM, Michael Salter wrote:
>>
>>     Interesting that you should bring this subject up Hank. I'm
>>     always on the lookout for a solution but, as yet not much has
>>     shown up.
>>     The primary issue is the "stalled" current draw of the M418
>>     starter motor of around 450 amps.
>>     I have found a 12 volt battery which will fit into the case which
>>     delivers 225 amps.
>>     Tests on my BN1 with around 9.5: 1 compressions show that it can
>>     draw something like 280 amps on a cold day at first attempt with
>>     20/50 oil.
>>     Once it has cranked over a few times this drops to under 200 amps.
>>     My BN2 with its standard 7.5:1 compressions only draws around 130
>>     amps from cold.
>>     I'm working with a battery company at present who have a "power
>>     sports" battery which would fit into the original case which
>>     delivers 225 CCA so it's likely that that battery would work with
>>     the BN2 but, because it is fuel injected I'm still trying to
>>     figure out if that battery has sufficient reserve capacity to
>>     provide the 8 amps the EFI system requires for sufficient time at
>>     idle.
>>     BTW, not wanting to burst your bubble but I'm fairly sure now
>>     that the 17L cases suppied by Antique Battery actually weren't
>>     correct for a 100!
>>     I bought  pair from Kent Lacy that were from the very low mileage
>>     car that he had and they are quite different.  I understand that
>>     the A B cases were actually correct for an MGA.
>>     This is, I believe, what the original Lucas battery used in the
>>     100 looked like.
>>     M
>>
>>
>>
>>     ------------------------------------------------------------------------
>>     *From:* Hank Leach <gradea1 at charter.net <mailto:gradea1 at charter.net>>
>>     *Sent:* Saturday, 14 November 2026 12:56:31
>>     *To:* simon.lachlan at alexarevel.plus.com
>>     <mailto:simon.lachlan at alexarevel.plus.com>
>>     <simon.lachlan at alexarevel.plus.com
>>     <mailto:simon.lachlan at alexarevel.plus.com>>
>>     *Cc:* michael.salter at gmail.com <mailto:michael.salter at gmail.com>
>>     <michael.salter at gmail.com <mailto:michael.salter at gmail.com>>;
>>     Healey team <healeys at autox.team.net <mailto:healeys at autox.team.net>>
>>     *Subject:* RE: RE: [Healeys] The Story of Positive Earth (and
>>     Electrics 101)
>>     Simon-long story about batteries. The brief answer is they are
>>     originally Lucas style (licensed) made by Antique Battery in
>>     Pennsylvania. (now out of business) They were dry charged and
>>     about $300 each. They lasted about 3 years and spit acid all over
>>     my RE and axle as they gassed/vented. Finally, in desperation I
>>     went to one universal 12V on the passenger (here RT side) which
>>     fit the tray.
>>     Since they were so accurate in looks, I could not bring myself to
>>     throw them away so I took Michael Salter's advice and cut them
>>     open, discarding the plates, and that is how they now are;
>>     cleaned up but empty-0 volts. I had intended to try Michaels
>>     solution but he did not have good results with the underpowered
>>     and dangerous Lithium batteries, so I am still in search of a
>>     12V. AGM (Lead/acid-sealed) unit small enough to fit inside the
>>     case. (like an ATV size) That would be a safer sealed battery.
>>     Not yet found one with enough CCA.
>>     In the meantime I am preparing the dummy side(LH) to be just a
>>     connection to ground, so that looking into the compartment, all
>>     looks sort of correct. There is a company on eBay, presently
>>     making one look-a-like 17L but without Lucas logo as they could
>>     not get Lucas to approve them-still costing $350 each and also
>>     dry charged old style spitting acid type. These I don't want.
>>     So as good as they look they are not currently functional in my
>>     100. Sad story. Waiting for Michael to come up with a solution.
>>     Hope he finds something and then they can be POSITIVE GROUND. Hank
>>
>>     --------------------
>>
>>     From: <simon.lachlan at alexarevel.plus.com
>>     <mailto:simon.lachlan at alexarevel.plus.com>>
>>     To: <gradea1 at charter.net <mailto:gradea1 at charter.net>>
>>     Sent: November 14, 2026 at 1:27 AM PST
>>     Subject: RE: [Healeys] The Story of Positive Earth (and Electrics
>>     101)
>>
>>     Great pics. Batteries look new. For interest’s sake – I have a
>>     BT7 – are they repros or are they still available or did you
>>     rebuild them with modern stuff inside?
>>
>>     They remind me somewhat of what our army called FFR Landrovers.
>>     (Fitted For Radio). Long wheel base, there were 4 BIG 12v
>>     batteries in the back. Hooked up in series and parallel so they
>>     pushed out 24v. Used by signallers. I always thought the latter
>>     were a necessary waste of space as they were always so intent on
>>     signals that they never ran the engine in order to keep the
>>     batteries charged. Those vehicles were a pig to start with a
>>     crank handle.
>>
>>     Simon
>>
>>  
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20261115/ff1a64e1/attachment.htm>


More information about the Healeys mailing list