[JAGNUTS] MGB fuel sender replacement procedure

[Bob]

Removed and cleaned ours in the spring.  I just used a long handled screw
driver, located it under a couple of the tangs (perpendicular to the rear
axle), a short twist and the sender was loose.

Bob

-----Original Message-----
From: jagnuts-admin@autox.team.net [mailto:jagnuts-admin@autox.team.net] On
Behalf Of Andrew Martens
Sent: July 25, 2004 2:23 PM
To: JAGNUT list
Subject: [JAGNUTS] MGB fuel sender replacement procedure

This week I will be replacing my fuel sending unit (73MGB). The only
instruction I have so far is to use a Drift Pin. Before I start bashing on
it, can anyone give me a little better guidance on its removal and on the
installation of the new piece?

cheers,
andrew
_______________________________________________
JAGNUTS Regina  -  mailing list 
REPLY TO : Jagnuts@autox.team.net
http://nonprofits.accesscomm.ca/jagnuts/Jagnuts.htm
_______________________________________________