[Shop-talk] Mega Penetrant - any good

[Nolan]

Went and did more Googling for you.  Supposedly, the test was the load 
needed to remove a dowel pin, put finger-tight in a cold-rolled 
low-carbon-steel bar before corrosion.

----- Original Message ----- 
From: "David Scheidt" <dmscheidt at gmail.com>
To: "Nolan" <foxtrapper at aceweb.com>
Cc: "Shop Talk" <shop-talk at autox.team.net>
Sent: Thursday, December 13, 2007 8:22 AM
Subject: Re: [Shop-talk] Mega Penetrant - any good


> On Dec 13, 2007 7:30 AM, Nolan <foxtrapper at aceweb.com> wrote:
>> Interesting!
>>
>> Did some searching around, and found these supposedly as the results of 
>> the
>> April 2007 Machinist's Workshop magazine comparison test.
>>
>
> Which, without knowing their methods, is just a chart of numbers.
> (Knowing what I do about Machinist's workshop, not knowing their
> methods is just as informative and meaningful as knowing them.)
> What are they supposed to mean?