[Shop-talk] genie garage door opener installation?

[eric at megageek.com]

typically, you build them on the floor.  Then the end hear the door goes 
up with a pin,  then you lift the other end up and attach it to the 
already hang angle iron  with all the holes so you can line it up better.

Moose
Everything I know about knots, I learned from Alexander the Great.



scott.hall at comcast.net 
Sent by: shop-talk-bounces at autox.team.net
12/15/2008 06:38 AM

To
shop-talk at autox.team.net
cc

Subject
[Shop-talk] genie garage door opener installation?






as always, I have the obvious question: 

I read the directions back and front, and don't see it...at what point 
does the assembly get attached to the ceiling? I'd think assembling the 
motor and rail on the floor and then lifting the whole thing would make 
the rail get misaligned. on the other hand, it mentions turning the motor 
and rail over a few times in the directions. 

right now, since it's not mentioned, I'm assuming the whole thing is 
assembled on the floor then lifted into position. has any one installed 
one of these things? 

hints, directions, etc. gladly accepted. 

thanks. 

scott 
You are subscribed as eric at megageek.com

Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive