[Shop-talk] throttle cable end/terminal (?)

[Tim]

Not sure what to call it but I would like to use a different
end/terminal that what was included with this carb linkage kit:

http://www.flickr.com/photos/82293958@N06/8928731354/

Looking for suggestions to replace the little bits you can see on the
left that has the cable stuck in it for the picture. (I do have a new
cable that is not frayed.) I donbt like how these little bits are
supposed to hold the cable. Also, it is all held on the rod by the
smallest and thinnest wire cotter pin I have ever seen. The rod on the
right is just the bare rod that will receive the replacement part that
holds the cable shown as a reference.

Whatta think?
Thanks
tim