[Shop-talk] throttle cable end/terminal (?)

[Karl Vacek]

Is the cable passing through a hole in the threaded portion of the stud,
between the two nuts?

If so, then it looks properly assembled though the nuts need to be tightened
to clamp the cable onto the stud.  As Pat noted, there would be a washer
between the cotter pin and the arm, and as you noted, a larger cotter pin is
in order.

Should work fine then.

Alternatively, you could use a bug nut.  Here's one style that comes in
several sizes:
http://www.aircraftspruce.com/catalog/appages/cablendbnut.php?clickkey=9629

Karl


-----Original Message-----
From: Tim
Subject: [Shop-talk] throttle cable end/terminal (?)
Not sure what to call it but I would like to use a different end/terminal
that what was included with this carb linkage kit:
http://www.flickr.com/photos/82293958@N06/8928731354/