[Shop-talk] Sheet metal question

Todd Walke racertod at racertodd.com
Mon Jun 3 19:09:57 MDT 2013


         My first thought was a cutoff wheel in a die grinder, assuming you 
have an air compressor.
         Mark the cut line with a Sharpie.  Go slow and steady using both 
hands to hold the die grinder and you can cut a fairly clean circle of that 
size.
         Cut towards the inside of the line then use a sanding drum or 
carbide burr to finish the shape and clean up the edge.


Todd
Seattle,WA
'86 GTI, Red of course. (exciting racey car) 276,000 miles
'01 Golf TDI, silver.   (new work car)       408,000 miles
'87 Golf, Polar Silver. (retired work car)   654,000 miles <- Gone to a new 
home :(
http://www.pureluckdesign.com <-Ferrari & VW stuff


More information about the Shop-talk mailing list