[Shotimes] Re: help.....valve chatter and rod knock...

[David P]

Mark,

    If you've taken the entire width of the bearing out of the equation,
where exactly did it go? In the cases I've seen where the bearing was
"removed from the equation", the piston was also removed from the block as
it no longer was connected to the crank. Not much of a way for the bearing
to get out of there without removing the bearing cap.


David P

95MTX



~
----- Original Message -----
From: "Mark Nunnally" <manunnal@netheaven.com>
To: "shotimes" <shotimes@autox.team.net>
Sent: Wednesday, October 30, 2002 21:58
Subject: Re: [Shotimes] Re: help.....valve chatter and rod knock...


>     It's probably a mixture of both.  Width of a std size bearing shell is
> like .057", which if you take that out of the equation the piston/rod
travel
> that much higher up in the stroke, which whacks the piston against the
head,
> on the sides of the CC.  And yes the rod is banging around on the crank
to.
>
> mark
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes