[Shotimes] Re: Climate control buttons

[Alan Fanning]

No. It's not that simple. To remove the buttons you have to scrape away some
melted plastic that acts like a rivet to hold down a piece that captures the
buttons. Then you have to glue this piece back in after replacing the
buttons. Not sure if the Gen 1 and Fen 2 buttons are interchangeable either.

    Alan

> need some help ASAP.  The buttons on my climate control have the usual
> cracked all to heck problem ( I don't know how that happened).  Anyway I
> recently purchased a front panel or face plate or whatever it is called that
> has the new type buttons.  The buttons seem larger than the old ones( Gen I ).
> Can I just access the front panel and snap out the old buttons and snap in the
> new ones?  I do not want to use the entire front panel because the "lens" or
> cover that goes over the florescent display has a rather bad scatch on it.  I
> have the instructions from FAQ and I have read what there is in Helms.
> Any suggestions?
> Thanks,
> David