[Shotimes] Gen1 gauge pod update

[van Oss]

We now have 18 paid orders, 2 more and we can proceed with design and prototype!  Thank you to those who have responded so quickly!
You have been terrific and I really appreciate you making my job easier.

A few words about the design of the pod:  If you look at the top front corner of your driver window, you'll notice there's a
retaining screw at that corner.  I think that's where we lap the pod over the stock trim.  Screw goes through both.  Should be very
solid.  Looking then at the bottom end of the pod, down by the dash, again you see there is a retaining screw right where the
straight section beside the dash meets the wider trim on the pillar.  (Look at your car, you'll see what I mean.)  With retaining
screws at the top and bottom of the pod, and maybe one somewhere in the middle (between gauges), it should be a very secure
installation, yes?

Comments welcome.

Joseph van Oss