[Shotimes] 95 SHO hard starting when warm

[Ron Childs]

It sounds to me like a CID sensor. Check your code to see if you get a CID. 
If so, replace the cam position sensor.

-Ron Childs  '91



>From: "john marmaduke" <jmarmadu@yahoo.com>
>To: <shotimes@autox.team.net>
>Subject: [Shotimes] 95 SHO hard starting when warm
>Date: Wed, 20 Nov 2002 21:06:52 -0500
>
>Hi, I'm new to the list, but have used the FAQ extensively.   I'm having a
>problem with my 95 SHO that I hope someone can help me with.
>
>I had the infamous check engine light, with the error code about the EGR
>valve.  Well, before I got around to fixing the "problem" I also started
>experiencing hard start problems when the car had been run, then turned off 
>to
>sit for an hour or so.  When I would try to start it it would stall and 
>stall
>and take a lot of on/off cycles of the key to finally get it to start.
>
>Well I replaced the EGR valve (this was before I read the FAQ) to no avail.
>This past weekend I removed the intake manifold and cleaned out the EGR
>passages in the intake and I also cleaned the IAC valve.  Now I only
>itermittently get a check engine light on (have not checked the code yet) 
>and
>I still have a hard start problem when warm.  What is going on?  Do I have 
>a
>bad IAC valve, a weak fuel pump, what?
>
>By the way, when the hard start problem occurs, I crank and crank and then 
>it
>will finally start, but sometimes the tach does not work then for the next 
>few
>minutes.  Is this part of the clue?  Is it the DIS module?   Help!
>
>Thanks,
>John
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes


_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*. 
http://join.msn.com/?page=features/featuredemail