[Shotimes] EGR, Intake Parts Identification

[Kevin & Cheryl Airth]

> I need some help in identifying some parts related to
> the EGR and intake systems on my '89.  EGR Part
> #1-Stamped with part #E53E-9J459-A2A.  It is a black
> plastic part mounted near the driver's side engine
> damper.  The two plastic? EGR vacuum lines enter it
> and there is an electrical plug.  EGR Part
> #2-Silver-colored metal part in the shape of a
> parallelogram.  It has two screws on top of a
> lid(something inside?) on opposing corners.  It is
> bolted to the engine block and is located just below
> the EGR and the metal tube of a heater hose.  It has a
> metal tube/bracket below going to the EGR exhaust tube
> and it has a gray electrical plug.  Intake Part #1- A
> black plastic can(about the size of a plastic film
> canister) with two vacuum lines mounted on a
> spring-loaded bracket.  It is located in the middle of
> the rear intake plenum.  One vacuum line goes into the
> rear plenum, the other into the following part.
> Intake Part #2- a black plastic part on the same
> bracket as the previous part.  One vacuum line from
> the previous part goes into it and it has a black
> electrical plug.  Thanks for your help!  I'm having a
> heck of a time figuring out which part goes with which
> name...
 Steve Ota chpsho89

Steve:
 The part #1-Plastic can is for the intake runner control and not the EGR.
#2 is the electrical solenoid that controls when the runners are activated.
Again not connected to te EGR.

 The metal box with two vacuum lines running to it is your DPFE.
Differential Pressure Feedback EGR sensor. Not sure what the piece bolted to
the block is?
.
.