[Shotimes] Re: help.....valve chatter and rod knock...
Steve Tatro
stevetatro@att.net
Thu, 31 Oct 2002 07:01:17 -0500
Read this. Then ask more questions ;^)
http://www.kurtmetros.com/bearings.html
Steve Tatro
Red/Black '93 with 163k miles
Cincinnati, Ohio
www.picturetrail.com/stevetatro
-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net] On Behalf Of Lee Kelsoe
Sent: Thursday, October 31, 2002 3:45 AM
To: Kevin & Cheryl Airth; SHO
Subject: Re: [Shotimes] Re: help.....valve chatter and rod knock...
ok...so when I buy these things....assuming the engine has never been
touched internally before, do I just ask for standard .000 or
what?...and what else will I need to purchase/have to do this
job...i.e., special tools(besides a torque wrench), and any replacement
gaskets...?
thanks again people....you all are great...
Lee "THE BIG SHO" Kelsoe
Marietta, Ga.
'92 MTX emerald green
225k and resting for a minute
> From: "Kevin & Cheryl Airth" <clubairth@cajunnet.com>
> Date: Sun, 27 Oct 2002 11:12:02 -0600
> To: "Lee Kelsoe" <the_big_sho@phobia.net>, "SHO"
> <shotimes@autox.team.net>
> Subject: Re: [Shotimes] Re: help.....valve chatter and rod knock...
>
>> so is it possible to replace the rods and mains without pulling the
>> engine?...please tell me this is true...
>>
>>
>> Lee "THE BIG SHO" Kelsoe
>> Marietta, Ga.
>> '92 MTX emerald green
>> 225k
>
> Yes. The mains are usually good. If on a tight budget I would just do
> the rods. Clevite #CB-1435P STD/25/50/75 mm. About $8.00 each
> .
> .
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes