[Shotimes] Front Rotor Warping

[ianf@eden.rutgers.edu]

What brand were the orginal rotors?

The 96 rotors will warp under heavy braking and fairly easily. 

How are your wheel bearings?

Ian


> A little over a year ago I upgraded my brakes to the 11.6 front 
rotors.
> When I did the conversion I used new pads, rotors, brackets, slider 
pins,
> calipers and backing plates.  The knuckles were purchased from a 
boneyard.
> About six months ago the car started to vibrate when braking.  I 
checked the
> front rotors and found that there were casting porosities in them.  I 
talked
> to the place where I purchased them and they agreed to credit me the 
cost
> towards a set of PowerSlot rotors.  Well, now six months later I 
again have
> a nasty vibration from the front end when braking.  My wife and I 
have been
> VERY careful with these brakes so as to not overheat them. (I DO drive
> rather hard but I use engine braking as well as brakes)  I talked to 
the
> shop where I purchased them and was told that the same situation had 
arisen
> with the owners car (powerslots also) and he merely had to take them 
out and
> REALLY heat them up to correct the problem.  I tried this, it seemed 
to work
> for a little while (couple weeks they were fine) but now the shaking 
is back
> and even worse then before.
> 
> Any clues as to why I can't keep a set of rotors from warping?
> 
> Jim
> '93 MTX
> perfect for that commercial where the guy is shaking his chocolate 
milk.
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes