[Shotimes] Re: strut rod bushings question

[Carl Prochilo]

Good note Luigi.  I was afraid that it wasn't quite so easy.  Sounds like
this will take a little bit more time than I had thought.  I'll allow
myself half a day (even after I've soaked the nuts).  Already got a
breaker bar from HF to free up those bad boys.

Cheers,
Carl Prochilo
92 Ultra Red Crimson

> The procedure is pretty straight foreward. I still haven't gotten to mine
> due to the subframe connectors not allowing any ratchet movement back
> there. I might have to remove the connectors to get to it. If anyone is
> going to get sfc's tell them to change these bushings and the fuel filter
> first.
> You may have to remove the lower sway bar bushings and endlinks to move
> the knuckle enough to get the strut rod through the hole in the body to
> access the bushing there. I'd get the Moog tpr's. Check Shonut's site for
> the part #'s.
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site design software
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes