[Shotimes] Rod bearings again

[Paul L Fisher]

Just the side facing the crank.

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 175K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus
Stainless Steel Y-pipe, '96 brake upgrade, Proportioning valve plugs, Delrin
sub-frame bushings, Amsoil Series 2000 0W-30 oil, Amsoil Synthetic ATF.

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from PayPal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message ----- 
From: "Bruce Malachuk" <bmalach1@nycap.rr.com>
To: "'`V6 SHOtimes'" <SHOtimes@autox.team.net>
Sent: Tuesday, August 19, 2003 5:31 PM
Subject: [Shotimes] Rod bearings again


> When I put assembly lube on the bearings do I put a thin film on bothe
> sides or just the side facint the crank?
>
> Thanks
>
>
> Bruce Malachuk
>
> 94 Opal Frost MTX
>
> 93 Black ATX soon to be parts
>
> 93 Green MTX - black interior.....soon to be mine
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.512 / Virus Database: 309 - Release Date: 8/19/2003