[Shotimes] Discharge Seal Size

[Steve Weinrich]

You can get these at AutoZone.  My post from last summer from the Forum
follows.

Made by Factory Air, called "Ford Springlock O-rings & Garter Springs." Each
blister pack contains 4 green O-rings of that size and 2 replacement garter
springs. Cost was $2.49 per pack.

3/8 " #26220
1/2 " #26221
5/8 " #26222
3/4 " #26223

I have not been able to find these on the AZ website. Also, several counter
persons there had no idea what I was talking about, until I found one that
had been there last summer and knew exactly what I needed. He got a ladder
and retrieved them from the top shelf.

Your mileage at your local AZ is likely to vary.....

Steve

Just get the scissors-like tool.  It has all four sizes on it and is much
more effective than the plastic ones also available from AutoZone.



----- Original Message -----
From: "Peter Maggiacomo" <gtsrider@yahoo.com>
To: <shotimes@autox.team.net>
Sent: Thursday, July 03, 2003 8:43 AM
Subject: [Shotimes] Discharge Seal Size


> Hey Guys, does anyone know the seal size on the
> discharge side of compressor just below compressor
> muffler? I need to order spring lock tool and seals,
> but I don't know if they are 3/8", 1/2" ?
> It's a hot SHO without ac this time of year in FL.
>
> Thanks,
> -Pete
>
> __________________________________
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
> http://sbc.yahoo.com
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes